ALITOVE 16.4ft 5050 SMD Red LED Flexible Strip Ribbon Light 5M 300 LEDs Waterproof IP65 DC 12V for Home Garden Commercial Area Lighting

Purchased for deck lighting on my bass boat. Very bright and easy to install. Also used them in the deck boxes.

Just what I wanted

These lights work well but are not very bright. If wanting bright led strip Id go with the double row strip.

These lights are super bright and they’re a great color. However, they get super hot when left on for a while, and the adhesive on the back pooped out after 3 days. If you buy these lights, buy some aluminum led strip channels to go with them and keep them away from anything highly flammable. Good for $15 but if you’re looking for a premium product, keep looking!

Add the sun back and had to pay for shipping so beware if you get these to read all about it

This is a good product but I had to return it. Make sure you separate the 3m paper from the glue since it is easy to pull the glue right off the light if you are not careful. this messed up my install.

They are bright. They have a nice silicone cover. I like that they have additional wires off the end. It allows you to use the left over piece if you dont use the entire roll. Quality control is a little lacking. The double sided tape was coming off the strip as you unrolled it. Out of 5 rolls, I had 2 instances where the double sided foam tape stuck to the backing for a couple inches. Not a huge deal in one application as they were laying flat, facing up. The other application, time will tell. The last problem was poor shrink wrap at the connector. If QC was a little better with better double sided tape, it would get another star.

Re-write of review....like others I have had the same problem with leds detaching, they work well but was hoping I had the answer for the adhesive issue, guess not. :( I will gorilla glue it back on tomorrow. Shipped quick and everything came together. Probably didnt need to order the extra add-ons that were suggested (did not use) but did use about six feet of the plain wire suggested for the short run to the power source. Adhesion seems to be mentioned quite a bit in other comments. I used a alcohol pad but you could use alcohol and a clean rag to clean the surface your adhering to....I had to pull off about 3 feet to fix a gap I left under a little section and it pulled off way to easy but I re-attached and it is holding up fine. It was the perfect size for a golf cart roof with about 18 leftover.....cut it and added my plain wire to power/switch and it works great. Very bright!!!

Ive been buying these for a few years for various uses. These ones are way dimmer than they used to be. Continued cheapification of popular products on Amazon.

I cant wait to install these LEDs under and around my Harley Trike.