Whiteside 6210 CNC Spoilboard Surfacing Router Bit, 1/4 Shank

Used this to cut a table top from a elm tree block of wood. Cut this without any problems and the bit is still sharp.

I use it for wood and epoxy and it does the job great! still hasnt gotten dull on me. You can never go wrong with white side

Works great, makes flattening my projects so much easier

You just cannot go wrong with Whiteside bits. I try to use them almost exclusively.

This is my favorite flattening bit hands down. I use it in my CNC machine as well as in a custom built router sled. It leaves very slight tool marks, that disappear almost instantly when you go over them with an 80 and then 120 grit sand papers.

This bit did a great job leveling the spoil order on my CNC router table.

I bought this bit to level and flatten some live edge rounds. I made a special table with adjustable rails and a trough to run a router back and forth across the rounds. The bit worked perfectly in my setup. My only regret is that I probably should have bought a wider bit to minimize the number of passes.

Bought this for surfacing my spoil board which was great. I don’t have a planer in the shop so decided to try planing some mahagony with it and that worked wonderful as well. Whiteside makes wonderful products at a great price point.

Once I surfaced my spoilboard I was able to properly tram it. Then I surfaced again and now all my cuts are dead on flat as the should be. This is a got to item!

This bit is a very nice bit, but needs cleaned frequently. Im picky and clean this after almost every use if there is a build up of pitch on it. Used mostly for flattening stock in my CNC.