SimbaLux Acrylic Sheet Clear Cast Plexiglass 12 x 24 Long Panel 1/8 Thick (3mm) Transparent Plastic Plexi Glass Board with Protective Paper for Signs, DIY Display Projects, Craft, Easy to Cut

I think these will do the job I need them for, but cannot get the protective paper off. Tried to peel, but that did not work. Tried soaking in water and soap for several days, but that did not work. Tried to scrape off, but that did not work. Plus it appears to be leaving the glue. I guess goo gone will be the next thing to try.

Purchased these panels for laser cutting/engraving, to use in LED night lights (base lights sold separately, of course). The acrylic cut beautifully, using settings found online as starting points. Resulting images were clean and good quality. There is protective paper on both sides of the panels. Left this in place during cutting (to protect cut edges from possible scorching) and peeled off the uncut areas of paper afterward. Larger areas of backing peeled off easily by hand, then cleaned up small areas of paper backing using a light duty (** non-scratching! **) Scotchbrite / O-Cel-O type sponge under warm running water. Paper peeled right off, leaving an unscratched surface and some really nice, custom made gifts. The images shown are about 7 inches high, and demonstrates how the led lights up the image. Note on the owl image that the edge is a little rough, resulting from my software trying to cut around the owl more than once. My fault in how I imported the image, not the fault of the acrylic panel. The others were nice and smooth after a single pass.

A nice sheet of plexiglass it has clean edges and is clear.

Both sheets I ordered were secured in boxes that kept the acrylic from warping, and then the two boxes were enclosed in another box to prevent them from being damaged. The acrylic also had a mask on each side to prevent scratches, and iad in cutting with a CO2 laser.

The Acrylic is great by being nice a clear like glass. The hard part is the protective paper was on with adhesive . It took almost an hour with goof off to get the paper off - and yes a big mess. At first it started to peel but about an 8 middle section on both sides refuse to budge .

To cover opening of shop AVR

This is nice acrylic, no issues with it, but 32% translucent was not enough for my needs, which was light diffusion in front of NeoPixels. I ended up getting 55% translucent acrylic which worked much better for that specific purpose.

I am new to laser engraving and cutting. I used this first order for experiments and fine tuning laser settings

I use this with my glowforge laser. Worked great. Decent price compared to what glowforge sells

Simbalux cast acrylic sheet products continue to impress me, so Ive bought from them again. None of my packages or products have been damaged upon delivery. Every piece of acrylic has been flawless. Prices have increased, but cast acrylic prices have increased everywhere. Great Job Simbalux.