SimbaLux Acrylic Sheet Clear Cast Plexiglass 12 x 24 Long Panel 1/8 Thick (3mm) Transparent Plastic Plexi Glass Board with Protective Paper for Signs, DIY Display Projects, Craft, Easy to Cut

Purchased these panels for laser cutting/engraving, to use in LED night lights (base lights sold separately, of course). The acrylic cut beautifully, using settings found online as starting points. Resulting images were clean and good quality. There is protective paper on both sides of the panels. Left this in place during cutting (to protect cut edges from possible scorching) and peeled off the uncut areas of paper afterward. Larger areas of backing peeled off easily by hand, then cleaned up small areas of paper backing using a light duty (** non-scratching! **) Scotchbrite / O-Cel-O type sponge under warm running water. Paper peeled right off, leaving an unscratched surface and some really nice, custom made gifts. The images shown are about 7 inches high, and demonstrates how the led lights up the image. Note on the owl image that the edge is a little rough, resulting from my software trying to cut around the owl more than once. My fault in how I imported the image, not the fault of the acrylic panel. The others were nice and smooth after a single pass.

I have no complaints with the plastic itself but the paper backing that you have to peel off it horrible! You spend about 10 minutes picking and scraping off little bits because it refuses to pull off in one complete sheet. A huge waste of time.

Covering some feral Cat houses I have.

I do paintings on acrylic glass and these sheets are perfect.

I used it for making a sign. I had purchased a thin, handcrafted sheetmetal sign and wanted another layer of protection from the weather so I sealed it inside two sheets of plexiglass. Worked perfectly.

Absolutely perfect clear piece of plexiglass. The only complaint I have is getting the packaging paper adhesive stuck to both ends off while unwrapping was very difficult. In fact I had to take a knife and chip a tiny bit off the corner in order to get a grab on it. Maybe cut it slightly larger so there is something you grab?

This stuff is really hard to cut, drill holes, no problem. The part that makes me mad is, Getting the paper off!! I try goo-off, soap and hot water, blow dryer, a scraper. I have watched youtube. It says easy off. Its not!!!!

I use it for doll bases.

I think these will do the job I need them for, but cannot get the protective paper off. Tried to peel, but that did not work. Tried soaking in water and soap for several days, but that did not work. Tried to scrape off, but that did not work. Plus it appears to be leaving the glue. I guess goo gone will be the next thing to try.

One product that was as advertised. Casted acrylic ran my first project and can tell a vast difference between the previous product I bought that claimed it was cast and this product.