SimbaLux Acrylic Sheet Clear Cast Plexiglass 12 x 24 Long Panel 1/8 Thick (3mm) Transparent Plastic Plexi Glass Board with Protective Paper for Signs, DIY Display Projects, Craft, Easy to Cut

Cut perfectly! Replaced my garage window with this plexiglass.

Cut and engraved nicely with my laser. These bag tags looked great because of it.

I have no complaints with the plastic itself but the paper backing that you have to peel off it horrible! You spend about 10 minutes picking and scraping off little bits because it refuses to pull off in one complete sheet. A huge waste of time.

These fit perfectly over my 2 1/2 gallon aquarium, but after sitting on it for a couple days, they curled quite a bit. I had not even installed a heater, so everything was room temperature.

Great buy

I love the aesthetic of chalkboard marker on this surface, as it serves as a blackboard for my home office. I hung it vertically next to a cork board and it looks beautiful. I only wish it were a little wider for symmetry reasons.

Used these acrylic sheets to make an inside lining for a metal box. They were thick enough to have to cut with a bandsaw rather than a cutting blade on a dremel but they were perfect for my project and the adhesive lining prevented them from splintering during the cutting process. Absolutely perfect for my project, would use them again in a heartbeat

Perfect for my application!

The Plexiglass itself is fine. However, the adhesive backing was really difficult to remove. It should have full tabs and something to make it easier to peel. I had to deal with finding a spot to pull from (and breaking a nail in the process) and then it didnt pull off in one piece. I had to peel off several pieces from both sides.

Material came as described. I used as a back plate for a marine thermostat that was replaced with a smaller size. I would go with slightly thicker next time but that’s on me.