XiKe 10 Pack Blue 2 Nylon Garage Door Roller 4 Stem, Quiet/Durable and High Load, Use 6200-2RS Double Seals Precision Bearings.

The MFG. says these are good for 100,000 openings? We open our door a average of 4 times a day which would be 1460 a year. That would mean around 68 years! Will I wont be around for the event, nor will our children. I will leave a note on the wall by the garage door with a possible date of needed replacement. Be safe everyone and enjoy life to the fullest, time really does fly fast.

upgrade my garage door

Bought these nylon coated garage door wheels and installed in about 15 mins. Removed hinges on all upper sections, slid out old wheel/shaft, and slid new one in, and simply screw hinge back onto door. Do yourself a favor and watch you-tube videos on how to change out since the bottom bracket holds the cable to your door lifting spring and should NOT be removed as serious injury can occur. Just had to raise door half way and bend out a small section of track with channel lock pliers to move the garage door in and roller/shaft assembly slid right out. Slide new one in, place back in track, and bend the track back in and good to go. Door very quiet and smooth now going up and down. Very happy with this purchase.

Rollers seem to be good quality but really didn’t lessen garage door noise.

Easy to install, but for safety don’t install with your door fully open.

working good fast to ship A+++

Would recommend these to anybody

I replaced these wheels in roughly 1/2 hour. As others have said, _dont_ use the bend the rail method. Instead, raise the door, replace the ones on the bottom by taking the bracket off -- on side at a time. Then, lower the door and do the reset -- one at a time. The door is nearly silent going up now, with the only noise caused by a worn-out opener sprocket that is next on the list!

These arrived quickly with Prime. Ive installed them on my door in about 30minutes. Watch the YouTube videos, the bottom wheels have to be done with the door halfway raised. Check the tension on the cable on the door sides before removing the wheel mounts. Once you replace the bottom wheels, close the door, and do the rest. At that point, there is no tension on the other wheels. Just DO NOT bend the tracks. This will cause undue stress on the track system. Do not bend the wheel tracks as some videos do. With a ratchet, remove the screws holding the wheels and its really easy to replace each wheel this way. Just always check the wheel is lose a bit, so you know its not going to pop-out when you lose the screws. No need to bend metals, or tracks. These are real quiet, seem solidly built. Its an affordable way to upgrade your garage door.

They work great. Still a little noisy but way better than medal ones that I had.