Truswe Cut Off Wheels 52 Pack,4 1/2 Inch,0.45 USD/Pack,Metal and Stainless Steel Cutting Wheel for Angle Grinder,Ultra Thin Cut-Off Wheel Cutting Disc (52 PCS 4-1/2 x .045 x 7/8 inch Cut Off Wheels)

product as described

I cut through this cast iron tub with 4 wheels that’s the same amount as i use from HD

A few feet of 3/16, 1/4, and 3/8 steel plate cut with no issues/wheel failures. The only warning I would give is when the first 1/8 inch of the wheel wears down they tend to spit out a bunch of abrasive for a second and then smooth back out right away. I typically wear the first 1/8 inch away on a thicker cast iron scrap piece before performing my cuts that need to be spot on.

Overall, a good buy. You burn through the disc a little quicker than you would like, but they havet been shattering on me or anything. Not to shabby

personal and work

Best bang for your buck!

Long lasting and will buy again

Cutting wheels worked very well i will be ordering again in the future.

EVERY one of these has failed-- They literally come apart when using. The edges fray after cutting one bolt. My mechanic had a piece that flew off and sliced his wrist, then a trip to the ER. DO NOT BUY THESE, they are literally an accident waiting to happen. Wish there were angry faces instead of stars....

They might not last as long as the box store, but for $18 for 25 or $0.72 each. They meet my expectation. Just beware I’ve seen price go up and down to $32 for 25. At the time of writing this review they are back down to $18. Another plus is these are not 5/8 hole, as a lot of cheap wheels are. These ones are 7/8. Not sure who even uses 5/8. These are a must have, add to your wall. In the picture I use these wheels to cut about 14 inches off each side of a plow blade for a forklift. And use them to put together a cart for a torch, and my meg welder.