Truswe Cut Off Wheels 52 Pack,4 1/2 Inch,0.45 USD/Pack,Metal and Stainless Steel Cutting Wheel for Angle Grinder,Ultra Thin Cut-Off Wheel Cutting Disc (52 PCS 4-1/2 x .045 x 7/8 inch Cut Off Wheels)

These cutting wheels are thinner than the Dewalt ones I’ve been using and they last around the same time. Happy with them so far.

I do not like the fact that they wear kind of quickly and some of them didnt have labels on them also there was three to four of them broken inside the package

These wheels work great and arrived in a timely manner

A few feet of 3/16, 1/4, and 3/8 steel plate cut with no issues/wheel failures. The only warning I would give is when the first 1/8 inch of the wheel wears down they tend to spit out a bunch of abrasive for a second and then smooth back out right away. I typically wear the first 1/8 inch away on a thicker cast iron scrap piece before performing my cuts that need to be spot on.

They might not last as long as the box store, but for $18 for 25 or $0.72 each. They meet my expectation. Just beware I’ve seen price go up and down to $32 for 25. At the time of writing this review they are back down to $18. Another plus is these are not 5/8 hole, as a lot of cheap wheels are. These ones are 7/8. Not sure who even uses 5/8. These are a must have, add to your wall. In the picture I use these wheels to cut about 14 inches off each side of a plow blade for a forklift. And use them to put together a cart for a torch, and my meg welder.

Used to cut a big rusted belt pulley. Fast and more effective than any air tool cutting wheel.

I have had better. But at double the cost. These are a great value.

They get the job done

great product

They work very well