Flexible Heat Resistant Silicone Rubber Sheeting, High Temp,Smooth Finish, Red 1/8 by 12 by 12 inch

Color was not as in the pic had to send back. More orange red.

Came rolled fairly tightly and now wont lay flat. Otherwise would have been 5 stars from me.

I bought this because I didn’t want to spend a fortune for the sublimation pads needed to press slate. It worked! They turned out great.

Well made product that works well for my application. 3 mils thick, very durable.

i used it to prevent burning my table when soldering

This product has no adhesive backing, so stickiness is not actually rated, but the Amazon system doesnt understand how to deal with that.. This is a high quality silicone rubber product. Very heat resistant, which is what I needed. I held a soldering pencil against the surface, set a7 700°F, and it does not mar the surface of the rubber. Thickness is a uniform 1/8 as specified. Excellent stuff, everything I expected, and a reasonable price as well.

I used this for an auto gasket application where a thick gasket was needed and it worked perfectly. Its tough and heat resistant.

If youve ever used a brake pressure bleeder then you know youve got to have a perfect seal between the bleeder top and the master cylinder reservoir. Well, there are a number of master cylinder reservoirs out there (re: Wilwood) that no bleeder top exists for, and since many of the cars that come through our shop have Wilwood brake systems we decided to make our own custom bleeder top, and the silicone sheet was used to make the gasket. It works perfectly and since its silicone the brake fluid wont eat destroy it. I also liked the variety of size choices they had available, it made finding what we needed much easier.

Needed to fabricate a stove Jack for Montana Elk hunt. This fit the bill! Extremely easy to cut with a utility knife. Kept the cutout and am using it for a hot pad in the kitchen. Works great!

I use this for hold my crappie jigs after I powder paint them.. I have to bake them most hang theirs upside down on oven rack..I took 2 pieces of aluminum angle drilled and tapped put this between them it holds my jigs upright so paint dont make jig like a conehead... works perfect look at my jigs on fb page Marks jigs