Adhesive Neoprene Rubber Mat 1/8 Inch (.125”) Thick x 12 Inch Wide x 59 Inch Long, Closed Cell Foam Sheet Roll

Used to make a replacement foam gasket on a floor cleaner. Worked well.

I ordered a set of TV trays and when they got here the paint wasnt anything too special it was a very thin layer, so I bought this to cover over top of it so that food and drink did not mess up the paint or warp or anything like that. I put it on it works great it absorbs heat, moisture doesnt get down to the wood and my TV trays are going to last a lot longer with this on it.

Used this to make my own drum mutes and it works great!

Have bought before and it works good on trapping cool/heat on terrariums.Some tanks get to and maintain 92(f) never had any adhisive fail/dry out.Will buy again.

I practically have an issue with an entire roll I ordered due to the adhesive being rolled up and and not able to adhere. Product would be great if the adhesive was stronger?

Definitely 1000% better than I expected. The density is substantial as I am using it for cushion/protection. I’m glad I bought this one.

This worked perfectly for me. I had to replace the foam that surrounds the kick plate on my 77 project car. The kick plate has a vent and door on it to allow air in. The existing foam seal that goes around the vent door had dried up long ago. So when it rains, water flows down the cowl drains, it goes inside the fender well and leaks through the kick plat because of the dried up foam. I cut the new pieces out using a utility knife. Luckily 12 inches die was exactly the width I needed. I then applied it to the kick plate the sticky part adhered to the plastic just fine. I installed it, put in the screws then put a garden hose down the cowl. No water got inside. I can now move on to restoring the floor of the car, as I could not do it until the leaks were fixed. The foam does not absorb water. I bought the 59 inch length for additional use on the car. I did not however remember to measure the length prior to my first cut so could not state if it was accurate. I got the 1/4 depth, and it was accurate as well as the width at 12 inches. I had no issue peeling the backing, nor any issue of the adhesive coming off the foam.

I couldnt peel off the paper fully. It just comes off partial and I can not put it on where I want it to be put on. I had to put screws to hold it. The surface was so slippery after I put it on the board.

I recently installed vinyl flooring and needing something to prevent our large couches from sliding. Unfortunately, the feet are 5 x 5 squares making it really expensive to buy commercial non-slip pads. I took a gamble on this and figured it would be a cheaper DIY way that let me make whatever size I wanted. I am happy to say that these have enough grip to prevent sliding while still allowing you to kind of move the furniture if you lift it just enough to not drag completely on the pad. So far, its been about a month, and we havent noticed any dust or anything clinging to the base of the couches or chairs, and the sound dampening has been awesome for pumps and a few other mechanical things that we wanted to quiet down :)

Product was as expected,very satisfied.