ZOKMOK Flush Trim Router Bits 1/4 Shank, Top Bearing Flush Trim Cut Router Bits Set, 1/4 Flush Cut Router Bits, Handy, Durable & Sharp for Home DIY
-
Andrew D. Hall
> 24 hourHave used one bit from the set so far. Purchased the set to cut a piece of Masonite to match a template. It made a very smooth cut and I could not distinguish between the size of my work-piece the size of the template. Have no complaints about quality of these bits, particularly at this price point. The only negative comment I will make is that the carbide inserts look to be on the thin side. So, I would enter the material gently and I wouldnt take a heavy cut -- but Ive only got a small router with a 1/4 collet, so thats not a problem for me.
-
A+S
> 24 hourI used these bits for trimming a routing table insert into a routing table I built. They worked well for this application. However if I was to do more frequent projects like this I would get a higher quality bit. If you want to use these for similar one off projects I would highly recommend. If your going to do these projects more frequently I would recommend a higher quality bit. During my experience with these I saw some burning of the bit and had to tighten the bearing a few times but overall they achieved the job I wanted. If I have similar projects with one off cuts I will get this brand of bits again!
-
Mark Hooglugt
> 24 hourNice set if you dont plan on using them for too many projects
-
Phillip Tenenbaum
> 24 hourI was in need of a cheap one time use and this bit did a great job.
-
Mara Reichert DVM
> 24 hourGreat for the price. I’ve used it on numerous hard woods and hasn’t gone dull yet
-
David Storrer
> 24 hourWorked great right out of the box
-
Bruce Heller
> 24 hourGreat for the price. I’ve used it on numerous hard woods and hasn’t gone dull yet
-
T. Killough
> 24 hourI really didn’t expect a bearing to seize during the first use. They do include a spare, but I’m disappointed I have to change it already. Besides the bearing problem, they work great. All in all, the bits stayed sharp after a good bit of use. I started spraying the bearings with wd40 every few passes. This kept the remaining bearings working.
-
gottalimit
> 24 hourIve only used these bits to make some recessed holes in some trays made of pine. They did a good job and made clean cuts. Thats all you can really ask for in a router bit.
-
adam netherton
> 24 hourI had some projects that were coming up and thought this might help with them. I didnt want to spend a lot of money if they didnt work for my needs. Today I pulled the 1/4 bit out put it in the router and about 30 sec in to the cut the baring screw came off. Thinking it was just a lose screw I proceeded to tighten it back up thats when I found that it was striped and just slides. I had to use the 3/8 bit to finish the cut Luckly it worked. Because I bought these is Feb, I can no longer return them so good news I didnt spend a lot of money on them. The 3/8 bit that i was able to use did fine with the red oak I was using it had minimum burn on end grain.