Yakamoz 2Pcs 1/4 Shank Top and Bottom Bearing Guide Flush Trim Pattern Router Bit Set Woodworking Cutter Tool with 10 Pcs Top Mounted Replacement Bearings

this is a cheapo. so go slow and chew less meat. best to run a variable speed controller and run it at medium speed. if you fail to listen to this then u get what you get. dont be stew pedd cheerz p.s. i would buy again if i blow this one up

The shafts bend too easily, I should have gotten the 1/2” shafts

Good variety of sizes. Works well... Still requires quite a bit of presure to drill hard resin.

This is a brilliant idea, since it is generally the bearing that goes on these flush cut bits. I bought this, fired up the router, went a couple inches on the cut, and the screw and bearing flew off. Alright, maybe it doesnt come tight enough to use from the factory. I retrieved the pieces, put it back together, tightened it, but the same thing happened. I repeated this process, tightening the screw until the allen key skipped in the screw head. It is thus not possible to tighten the screw any tighter with the allen key. Well, the screw and bearing once again flew off after a few inches. This time I reassembled, tightened to the max with the allen key, then tightened further with my vise grips. The screw snapped off, rendering that bit unusable. Moved to the second bit, tightened to the max with the allen key until it skipped in the screw head, then gave just another 1/8 turn with the vise grips. Perfect! Fired up the router, cut a few inches, the screw and bearing flew off again. So I conclude: brilliant idea, but unfortunately does not work.

Nothing to dislike. Its well made and has a quality feel about it. I have used it to drill small holes in 7 mm plywood with a couple of the supplied twist drills. I would recommend this product

Como se ven en la imajen , buen material y precisos.

Ive used this once to drill holes into 2 copies of super smash bros for nintendo 3ds... if you need a product that is appropriate for that very specific task, look no further. Bits were quite sharp, and it was easy to use accurately.

The handle is exactly what I wanted, however when I tried to use the drill bits to drill into soft plastic for miniatures, it was useless. I swapped the drill bit over to something I already owned, and it drilled perfectly. If you buy this, be prepared to buy some drill bits separately.

My guitar top was over the size of the back and so I flipped it over and put this bit in my router table adn slowly worked my way around the guitar body. It did a beautiful job at replicating the wall of the back of the body on the faces edge to match. The blade isnt blunt or chipped after that job and it hardly smoked or heated going at a reasonable speed. because of the cheaper quality make sure you go with the grain or there WILL be tear out of the finer more delicate edges. tape up and do it right the first time. Thumbs up. PS. keep in mind a half inch shaft will not fit a domestic router bit hole. It has to be a quarter inch. Quicly arrived and well packed with their own little hard plastic cases, really stoked. Thank you.

Pretty trash. The bits aren’t sharp enough to make a dint in 40k minis. The handle does what it should, so I just got some higher quality bits from Bunnings.