Wolfride 4pcs Long Shank Tungsten Carbide Burr Set 6mm Shank Die Grinder Burr Set for Metal 6-Inch Length

using for boat fiberglass repair, and very satisfied so far.

They tend to wear down too quickly for being cobalt.

these are listed as use in die grinder,these will wobble and bend when grinder is turned on, I cut length down to 4 on a new one and it still was so out of balance it almost hurt me, needed to complete a task so ran in a 3000 rpm drill and was able to use it. I would caution you to not spin these very fast. you might get hit in the face.

Manufactured to high standard the shank is strong and grinding tips seem to work on most materials.

Did.job

exelente producto funcional al maximo, es de muy buena calidad, resolvio mi problema

Good overall, use then on my knife making projects..

Very well-made and strong stay sharp for a long time I used mine on cast-iron and they Are still sharp

The Steel used for the Shafts is Waay too soft. As soon as I turned on the Die Grinder, the Shaft bent 45 degrees just above the Collette. Just to make sure the one Cutter was not defective I tried a second one and the Same thing Happened. I then Cut off the 5.5” Shaft down to 2.25” and tried it again and at least the Shaft did not immediately Bend. Now to see if the Shaft is Strong enough to do the Light work on some Aluminum Without Bending so bad it becomes Useless.

Broke with in 5 minutes of use. Was using to bore a nut bigger for a bearing driver ended up using a socket.