Thermalright Intel 12th/13th Generation LGA1700 Anti-Bending Buckle,CPU Stress Bending Correction Fixer, Curved Pressure Plate,Fully Fitted and Fixed Without Trace Installation (Black)

Easy to install and help with thermals

This is my first build in 4.5 years, so this time around I wanted to do tons of research. Im installing a CPU water cooler for the first time ever and researching that a fair amount led me to these CPU brackets. Ive never been satisfied with the cheezy, light weight CPU brackets/fasteners which come standad on MBs. This seemed like a valuable asset for just $14. Im running a 13th Gen Intel on an MSI Z690 ACE MB. As you can see from the pic, the fit looks very clean and the aluminum bracket is well machined. I do not know if temps will be lowered vs the stock guillotine bracket but it sure holds the Intel in place far better. And that can only be good.

I tried this modification because I didnt like how much torque was being applied to my CPU when using the stock fastener. I am not sure if it was actually bending the chip but it was under too much pressure in my opinion. Temps improved slightly. Easy to remove original and install and looks cleaner than original silver clamp. Comes with tool to remove and reinstall screws.

This does what its supposed to do!

Work as advertised, easy to install.

Well worth it.

When I bought my i7-13700K, the CPU would randomly spike to 100 °C while idle and stay at that temperature for 4 to 5 minutes. I upgraded my CPU cooler to a corsair 420 mm CPU watercooler, but the same issue occurred, although it didnt stay as long at 100 °C. The problem disappeared when I switched to the Thermalright contact frame. I also noticed an improvement in the average temperature of the CPU at idle and under load. It is clear that this contact frame helps the CPU behave in a better way, especially for a CPU that is known to overheat.

Works. Got my temps down a little bit.

Fácil instalación (tienes que ser extremadamente cuidadoso) se instaló con un procesador y motherboard nuevo, ayudó bastante en las temperaturas

Purchased this for my first Intel build ever. I installed this after using the stock bracket and seeing some relatively high temps. A quick search of Reddit brought up many recommendations for this, so I picked one up. It’s reduced the max temp on my 13700k from around 90c to about 85c with my EK Nucleus 360mm AIO. Definitely worth the cost IMO, even came with free thermal paste. I didn’t use the paste, but it’s a nice touch for sure.