Thermal Grizzly Kryonaut The High Performance Thermal Paste for Cooling All Processors, Graphics Cards and Heat Sinks in Computers and Consoles (1 Gram)

So I have always heard good things about this stuff. I was redoing the paste on my RX580 and thought I would try this instead of my Corsair TM30 I already have since I read it dropped temps for people.

Im going to use the product to drop the temperature of my AMD Ryzen 2700X / CoolerMaster Pro 280 AIO. The directions were extremely poor. They should have pointed to a web address to see pictures full screen.

Jai un pc portable MSI équipé dun i5 7300HQ, dune GTX 1050 ti 2go de Vram et de 16go de mémoire vive.

Prodotto che ha superato le aspettative! Molto facile da applicare grazie al tappo apposito!

I am still gaming on a near-10 year old custom build. I have two XFX Black Edition Radeon HD 6870s in Crossfire, with the top card always struggling to breathe due to the close proximity of the two. Lately, the top card had been running at 98-100c, and the bottom card at mid 80s to low 90s c during hard gaming. I took apart the cards to find the original thermal paste had turned into dry clay. After a clean-off, along with cleaning and oiling the fans, both cards now run about 20 degrees cooler, and without ramping up the fans to 100% like they used to do. Since I used it on GPUs, I used the spreader to get a good coating on the entire die. Before using it, I left it (in the bag) in hot water to get it warmed up and soft. It was easy to work with, using the included spreader. Highly recommended if youre running older cards running way too hot, that need new thermal paste.

I bought this to see if it would make a difference cooling an Intel i7 4790 cpu that ran unusually hot under stress test conditions when paired with an ARCTIC Alpine 12 CO cooler (which is slightly better than the standard Intel stock cooler). It may be that this particular chip needs to be delidded anyway - and I know that temps on these cpus can get higher than they should running AX2 instructions sets (something that was rectified by Intel later).

I have an Acer Aspire V3-551G-X419 (2013) and it had been overheating for years. Even simple tasks like watching a movie would overheat the system, it just turned off when the CPU reached 100C. I removed the dust from the heat pipes (copper) and applied this thermal paste to the GPU and the CPU. My notebooks idle temperature changed from 80 C to 50 C on High Performance and it doesnt go over 70 C when fully loaded. The volume of product is not much but I expect it to last a few years and I have another application in the tube. It was my first time replacing the thermal paste and it was very easy, I also had no rush. Im very happy with the product and my notebook feels like new.

It’s very good

Its good stuff, albeit overpriced. I dont notice any difference in temperatures versus cheaper paste.

[21/08/2016]