POWER / SWR METER CB Radio 100 Watts w/ 3 Jumper cable - Workman SWR3P & CX-3-PL-PL

use it every day

All you get is the meter the cable did not come in the packaging. I only purchased this one over another on Amazon because this one suppose to come with the needed patch cable like shown sitting on top of the meter in the description photo. Meter works good and no issues there but not sure its worth the extra money without the cable when compared to a cheaper one on here. Update: The Cable showed up 2 days later and label showed it was shipped from another location same day. All good now but seller should list this in the description as I went and purchased one at radio shack not knowing they sent it separate.

Very good SWR meter for setting the antrnra on CB.

product as described works great

Easy to use

Very quick ship. Exactly as described.

Excellent meter. Everything needed is included. Very compact design. I was able to tune two of my antennas fast and easy. I would recommend it to my friends.

Pros: Metal casing, solid construction, looks nice, performs well. Cons: VERY POOR INSTRUCTIONS for testing field strength, unit doesnt sit level on a table and rocks back & forth each time you touch it. There was a VERY loose nut inside the unit that I had to tighten, NO ILLUMINATION for night time use, cheap jumper cable included. Okay, now here are some tips on making this a better purchase. First, if you want to test field strength, do some research online. All Ive found so far is that this unit uses the Bridge Method to measure Field Strength. Second, while there is no illumination, there is ample room to add it yourself. Simply tape a LED over each meter, u will need to either install a battery inside the unit to power the LEDs or use an external power supply. In either case you will need a toggle switch to turn the lights on/off. Third, if your unit has an uneven bottom like mine, you can mount the unit under a shelf to make it more stable and easier to work the switches. You will have to loosen the nut holding the tiny antenna and lay the antenna horizontal, then re-tighten the nut. With the antenna out of the way, the unit will now sit flush under a shelf. You can remove the outer case, drill a couple holes, then screw the case in place under a shelf, then slide the unit back into the case and secure it with the 2 rear screws. You can also install the unit on top of a shelf by drilling two holes in the bottom plate and getting them snug enuff that the unit doesnt rock back and forth. But this unit looks much better under a shelf as it hides the coax well. I would have given this unit 5 stars but the crappy directions alone are enough to take a star away. Everything else is a manageable annoyance and most problems are easily resolved with some HillBilly engineering. Finally, replace the included jumper cable with a better quality jumper.

Works as described

H is only 2.25 inches, L is 5.5 inches, W is 2.5 inches bottom and top W is 1.75 inch. Its not 6x 6x 6 !!!!