PGN UCP205-16 Pillow Block Bearing - Pack of 2 Mounted Pillow Block Bearings - Chrome Steel Bearings with 1 Bore - Self Alignment

(0 reviews)

Price
$20.40

Quantity
(10000 available )

Total Price
Share
46 Ratings
29
7
2
2
6
Reviews
  • fordfan

    > 24 hour

    Nice product

  • > 24 hour

    Roule sans bruit

  • chiflatin

    > 24 hour

    Solid bearing, its able to adjust slightly which is really good for less than perfect installations. Reviewers mention its crooked which is silly because you just it adjust it to fit and it stays perfectly straight, thats the whole point. Im using mine on a garage door spring bar to keep the ends from moving up and down as the bar flexes and bends. This bearing is Perfect for this since it adjusts, like its suppose to, to point in the correct direction and keep the movement up and down in check.

  • Running Man

    > 24 hour

    I took a chance on these based on reviews that mentioned these bearings are self-aligning. Perhaps they are, but the hole bored through the casting that the bearing is pressed into is obviously bored at an angle relative to the rest of the casting and not in line with the mounting holes. I would either need to mount the casting at an angle or hope the self-aligning internal ring of the bearing did not cause ball bearings to run out of the internal raceway causing wear and premature failure. Pulling and replacing bearings is chore enough without worrying about doing it again sooner than necessary due to early failure of the part you are installing. I decided Im not risking it and returned them. Other than that, they appear to be of good quality and, if you can mount them slightly offset so the actual bearing itself is in line with the shaft, would probably work for you just fine. I dont have room to offset these on my brackets, so they are on their way back for a refund. I would be willing to try these again if I could confirm that they are being machined correctly or if I had an application with a little room to mount them at a slight angle.

  • NATHAN DUPLANTIS

    > 24 hour

    Bought them for a barstool racer build

  • Tim

    > 24 hour

    I have two sets of 1” under a heavy load and they are solid

  • Tom H.

    > 24 hour

    The ISO 9001-2008 died a few years ago. If you didn’t receive the 2015 rating, then you failed ISO requirements and can no longer say you are ISO certified. Who writes these things for these products?

  • william senft

    > 24 hour

    Like

  • James Trotta

    > 24 hour

    installed works well

  • Mark W.

    > 24 hour

    Fast shipping and works great

Related products

Shop
( 104 reviews )
Top Selling Products