MIKING 6 Pack Plexiglass Sheet, 12” x 12” Square Panel 1/8” Thick (3mm) Transparent Acrylic Sheet with Protective Paper Use for Crafting Projects, Signs, DIY Display Projects

Product was not wrapped in paper as described. Was in plastic which was not conducive to laser engraving. Pulled and bubbled, not very happy with this at all. Edit: Seller says they do ship both paper and plastic wrapped versions. They made good on the situation and refunded my money.

As expected

Great product

Just as described! Laser great with great clear cut edges. This product came packaged carefully and in great condition.

I made my desk out of a bunch of processed timber planks. Looks great but the desktop is uneven. I got the idea of putting these plexi panels under a desk mat that was roughly the same size as three of these side by side. I taped these together, layed the deskmat over the combined panels. Now I have a flat desk.

Was as described in description was not clear on needing to peel the plastic part to reveal the clear plexiglass but was contacted by seller to clarify everything thank you in advance will order again

Ordered the 6 pack and was only sent 4 of the 6... Quality is good and clean but just upset about being shorted

Used this as divider in gerbilarium (separates high & low bedding areas) (plus Gorilla tape:) for a 29 gallon tank and its perfect.

Excellent value. Cut like a dream on my glowforge. Will re-purchase.

I ordered this for a project and had intended to cut it with my laser engraver/cutter (that was a mistake...). The acrylic comes with protective film on both sides that comes off fairly easily when you are ready to install. I verified the thickness accuracy by checking the edges of the original piece and my cut pieces with a digital caliper and every measurement I took came out the same at 2.98mm (I have a cheap digital caliper). Once cut the pieces all looked great without the clouding or distortion that you see in similar products. As far as the mistake on the laser, it was not powerful enough to cut the piece and ended up just scoring it, and leaving a bad edge on the test piece, which is user error and I dont attribute that to the manufacturer of this plexi.