Metal MIC HOLDER / Clip - Screw In for CB / Ham Radio - Workman MH2

I use this for mounting my mic in an F150 - two small holes drilled to attach the mic holder and my mike is just where I want it. It fits my mic perfectly and snugly and does not rattle - not much else to say about it - no moving parts and works perfectly.

Had to flaten it a bit so it would fit where I needed it. It worth the money though

Picture description shows 2 screws but they werent in shipment.

Pretty much like you would expect.

Works fine a little expensive

Good fit for my HF hand mic.

Good quality

Great replacement for a factory mic holder. Works perfectly for my Kenwood TM-V71a.

I bought this to mount on the side of my Cobra 29 CB. The only issue I had was the screw not tightening up all the way. I used existing holes in the side of the CB and apparently the screws that come with it are too long or something so it is loose on the side of the CB. It does still work fine and Ive not had any issues with it.

I bought three. The chrome plating was messed up on one of them; looked like it was chromed over corroded or unfinished metal and wasnt very presentable. All three of them had very poor, rounded, imprecise bends, unlike picture. The mounting surface was at a different angle from the hanger part, causing the hanger to lean outward. The holes were too close to the first bend, preventing the screw heads from sitting flush. I found these unacceptable enough that I bought three from Cobra Electronics website. Cobra has a standard and heavy duty model, both of which are far superior quality to this.