MAGZO Adhesive Foam Pad 1/4 Inch Thick X 4 Inch Long X 4 Inch Wide, Closed Cell Foam Sheet Square Rubber Pad Anti-Slip (6 Pcs)

Had some rattling fans. A razor and a few minutes is all it took to apply bits of this where needed. Problem sorted. Put it where metal meets metal.

poor adhesive that over runs the edges and bunches up. I work in adhesive manufacturing and this is substandard. The adhesive is too thick,rubbery and sticky with out tensile strength. Its also hard to remove from the backing appears to be heat damaged and at least one square is made up of two smaller pieces stuck together. I gave it two stars because maybe it could be used for something but I cant use it. Im willing to accept that I got a bad batch but I received is just a bad example but this type of product is supposed to be much better. oh yea, the smell is very bad.I will be returning it.

Great Item for use with Magnetic Light Bars to give cushion between Magnetic and vehicle body.

A few of mine had cuts up the middle so I didnt get all full intact squares. Also they didnt measure at full thickness. But more importantly they did not stand up to impact like other rubber products Ive used. They tore too easily even though they appeared to have quick rebound. I guess they were just not supple enough. I did give my feedback directly but didnt hear back so I figure Id share with others

Very strong

This was used to line - of all things - a shoe. Specifically, a pair of Crocs. Thick enough to protect against Crocs little bumps, thin enough not to make the foot hit the top of the shoe. It might be better to buy this in a sheet, but the squares did work.

I purchased this for the bottoms of my stainless steel tumblers and it works very well for that. It doesnt absorb the water and it sticks very well. I dont know how well it would hold up to a dishwasher but most of my tumblers said not to put them in the dishwasher anyway. This size is good to do at least 3 or 4 tumbler bottoms from each piece.

Used it on my new fuel tank

Ive been looking for some time for thin sheets of non-slip padding to use on the bottom of miscellaneous stuff to keep it from sliding around. I finally came across these and they work great! I always worry about how good the adhesive will be on self stick stuff but this exceeded my expectations. So far Ive used it on a few 3D printed plastic parts that usually are very slick. It has stuck well to the part and prevented sliding.

I bought these to put into a cosplay helmet. The helmet was a tad loose and needed something to keep it in place (My wig wouldnt do). I decided to buy these and put them inside of it. The padding was just what I needed and as described by the seller. I did not have a problem with the adhesion, or cutting the pieces down to what I needed. I plan to buy more in the future.