Duco ABS Plastic Sheet 1/8 Inch Thick 8 x 12 - Two-Sided Rigid ABS Sheet (Textured Plastic Front & Smooth Back) - DIY Home Decor and Robotics Competitions Use - Black Plastic Sheet (Pack of1)

Tough material, strong but not so easy to cut. Used hobbyist razor.knife to cut, difficult, razor saw works better if appropriate for job. Pebble finish very glossy. Can be scored & cracked..

Exactly as advertised. Cut neatly to size on my table saw.

The smooth side of the plastic needed to be abraded to remove the voids, not a good molding process

Used to keep chicken poop off the 12” Ouyolad chicken brooder. Drill the holes then heat the plate with a cheap heat gun. Easy to remove and wash. Had to “mold it” a bit after drilling the holes for the legs. Used a Harbor Freight heat gun. Very easy.

First, the positive: the quality and thickness of the plastic are acceptable. My sheet of ABS plastic turned out to be 7-7/8 x 11-7/8. The seller messaged me to point out that this product is manufactured to host a 1/8 tolerance. Seems like quite a coincidence that both dimensions were short by 1/8.... almost as if intended. I see in another review that the customer received an item short by 1/4 in both dimensions. Long story short (pun intended), if you need exactly 8x12, you may need to do some extra due diligence to make sure your item isnt a victim of tolerances. To the sellers credit, the return was approved.

Took awhile to get here but it was well packaged and un damaged. Clean shiney side and textured side . Stronger than I thought it was going to be. But thats a good thing. perfect !

EASY TO WORK WITH----- USED FOR SPEAKER SURROUND

In some places I could just cut a 2 x 4 section of this and use plumbing ABS cement to glue the pieces to the inside cracks. Where the carrier was curved, I heated the ABS with a harbor freight hot air gun, and then with heavy gloves, held it into the curved areas until it cooled into shape. I then cleaned all parts with 90% rubbing alcohol, added ABS cement and glued into place. In areas where I filled in holes etc, using this, and a lot of ABS cement is took 3 days to finally harden, but overall very satisfied and allowed me to save my cargo carrier which was damaged after someone drove into unground garage.

I used this for a replacement to the bottom panel of my RV door. A oem replacement wasn’t available but this product worked perfectly.

Well, I measured both pieces and both are like 5 3/4”x11 3/4”.. Not a huge deal but definitely not accurately cut. And the smooth side looks horrible. I was debating which side I wanted visible but given the condition I’m left with only the textured side.