be quiet! BGW34 Pure Base 500 Window Black, ATX, midi tower computer case, tempered glass window, two preinstalled fans

After reading another review I decided to cram as much cooling as I could fit in this case. I installed 3 140mm fans with a 280mm radiator on the front. I did have to do a little shaving down on the top and bottoms of the middle fan but managed to get it to fit. I then installed 2 more 140mm fans on the back side of the radiator. I put another 140mm on top and on rear but because the hoses of the radiator I was only able to fit a 120mm on the second slot on top. Running a I7-12700k at 5.2mhz on Performance-cores and 4.2 Efficient-cores with max temps at low 60s. all that and still manage to fit both mechanical drives in their bays with their temps maxing out at 37 degrees.

Recu dans les délai annoncés, déballage OK , installation nickel, quelques dizaine de minutes pour gérer le passage de cable, et hop on allume. Quel silence!! Quel plaisir!! On entend plus que le ventilo de processeur (loriginal du fabricant), ya plus qua le changer pour allez encore plus loin dans le calme. La gestion du rgb nbe peut se faire que si votre carte mére posséde une prise rgb 3 pin (5V), la mienne ayant un connecteur 4 pin (12V), jattendrais avant de prendre un boitier pour lié le tout. Ca nempeche pas le rgb du boitier de fonctionner et de se gérer avec le bouton idoine. Je suis trés content!!

I love nearly everything about this case. The cable management is excellent, style is elegant, and most of all the mesh filters are amazing! The filters are the one thing that really put this one over the top when comparing this case with others for me. Few other cases I was looking at had them and the fact that the ones on this case are (relatively) easy to remove and clean allows me to keep the airflow optimal and the dust levels of the internal components to a minimum. If I didnt have this case, I know I would have to open the case, take it outside and blow it out with a can of compressed air every month or so, which would have been a huge hassle. Instead I can just take of the filters every few weeks, give them a quick rinse, and theyre good to go for another month. The front filter is a lot more of a hassle to clean because you have to pop off the front panel in order to access it. I am a bit concerned that after doing this a couple dozen times that the clips that secure that panel to the front will break, though I remain optimistic. If they would have made it to where the filter slid out from the bottom (like the bottom filter does) it would be a lot more convenient and I would have easily rated it 10 stars out of 10. Its still better than pretty much every other case in this price range though, especially if you live somewhere even remotely dusty, or for example, if you have pets. I dog-sat a couple of times and the amount of hair and dust after watching the mut for a couple of days astounded me. To think all of that hair and dust would have otherwise been on my relatively spendy motherboard and other components (possibly causing them to short out over time) makes me cringe. So, I would highly recommend the case for nearly anyone, unless you absolutely need components that wont fit (e.g. if your building a custom loop, liquid-cooled system). The heatsink/fan I purchased is a pretty large CoolerMaster model and theres still roughly an inch to spare, so it does provide for good air cooling options, as well as compatibility with AiO liquid coolers.

Moins isolant niveau bruit que mon fractal design qui avait des parois lourdes et épaisses. Je déplore également que le cache supérieur blanc amovible soit percé mais ne comporte pas un petit filtre grillagé, une petite vis peut potentiellement chuter a travers, cétait pas dur de coller un grillage anti poussière.

The material quality is nice on this case, the fans are quite, I would have preferred thumb screws or latches to the plastic push clips on the front panel or a slot to be able to remove the front filter without risking breaking the front panel every single time it needs to be dusted. Slot for cable management could have used a little bit more space and maybe a rubber gasket to push cables though with a little better concealment.

I was looking for a mid-tower case that supported a top side air cooler. RGB was not factored at all in the decision making. I did a lot of research and this one always got good reviews. I was pleasantly surprised, when I started assembling, at the well thought out design. It was very easy to route all cables and to manage them in the back space provided. I loved the PSU backplate because after putting it all together I realized that I needed another sata power cable put onto the module. It took less than two minutes to get the PSU out, cable attached and back into the case. I am not a real fan of RGB but I find this setup to be simple and elegant enough to leave on. There is a button on top to turn it off if I so please. Also the air flow seems to be superior because the temperature has lowered by 3 or 4 degrees C and has become more stable even at idle. The noise Level is no less than any other case that I have used. If there is one wish that I would have it would be have more external inputs up front. There is only 1 type connector and 1 USB 3.0.

Optisch genau mein Ding. Schön schlicht, ohne diesen RGB Kram. Gut verarbeitet und günstig.

Um ehrlich zu sein habe ich mir da mehr gehofft aber man kann damit leben. Die Qualität ist gut aber die Form gefällt mir nicht so

Love the case very quiet and plenty of rgb lighting

I love this case, I needed a quieter, smaller case with filters ( we own a Parrot! ) to keep out dust and floof!