Amana Tool 45624-K SC Spektra Extreme Tool Life Coated V-Groove 60 Deg x 1/4 D x 31/64 CH x 1/4 Inch SHK 3-Flute Router Bit

This bit gives a much cleaner cut for inlay than any other bit I have used. The higher quality cut allows me to use finer detail in the inlays. Worth every penny!

I used this bit to do inlay. It’s very sharp and cuts awesome

Cuts ok, but it doesnt clear any chips. It mostly pushes chips back into the cut, at least for the job I was running, which was engraving. It worked good for outer chamfers.

Was excited to step up to a 1/4 60 degree bit from 1/8. This bit only last one sign cutting yellow pine. Broke one minute into the second sign. My 1/8 bit cut 22 signs so far and is still going strong with the same settings. Bit is junk as far as I am concern. Waste of my money and time.

I bought this bit in June of 2022 and am still using it. I have used it for about 150 wood carved signs and logged about 50 hours of use and it is still going strong. This thing stays sharp and just keeps going and going. I love that it is 3-flute as opposed to the 2-flute v-bits I had been buying from Menards and Lowes.

Using it to make signs with just a Dewalt DCW600 and follow it up with a 1/4 end mill bit. Works great with zero issues. With Amana bits Ive always had great results.

Was only able to make a few cuts before the bit began to wear down to the point it was unusable when cutting purpleheart inlays.

nice and sharp.