1/4 Inch 6x12 Aluminum Sheet 6061-T6 Aluminum Tooling Flat Sheet Plate Bar Mill Stock

The width was not cut to true 6 inch dimension, closest mm. OK as I only needed 5 inches for my project. a little gummy to machine. I am not sure which version of 6160 it is.

The product was great. I asked for a refund only because I ordered the wrong width.

good quality as advertised

Very clean, well packed for shipping. The corners had had hard plastic corners on it to protect it if it were to get dropped on an end or edge. Wrapped in a protective film so there was no oxidation. It is a bit expensive but I couldnt find anything in this size near me so I mark it up to the cost of shipping and handling. Its exactly what I was expecting.

A

good quality

I cut my finger as I was removing it from its cardboard box . I had to take a file and go over all the edges as cuts and splinters abound. Otherwise a good product. Bruce

I had to make new hinges for a Harbor Freight folding trailer after I chose th use 1 lumber for the deck. The new hinges allow the trailer to fold with a thicker deck and are sturdier than the original hinges.

No

I installed a ladder on the boat that requires a minimum 4x8 backing plate. This fit in there just right with some small trimming.